Thorough HVAC & Water Heater Services in Taylor, MI

Completed full HVAC system installation including a 70,000 BTU furnace and 2-ton air conditioning unit. The outdoor condenser was positioned on a concrete pad in the rear yard with proper electrical conduit and refrigerant line connections run from the exterior wall. The furnace was installed in the attic space with complete PVC condensate drain piping system and flexible ductwork connections. All mechanical and electrical connections were completed, tested, and reconnected to ensure proper system operation.

Completed electrical estimate for new whole home generator installation at manufactured home. Assessed existing electrical panel configuration and available space for generator placement. Documented current electrical infrastructure including main panel and sub-panel to determine integration requirements for automatic transfer switch and generator connection.

Responded to no cooling call on 9-year-old central air conditioning system. Upon arrival, confirmed outdoor unit was energized but not producing cold air. Inspected outdoor electrical disconnect box and found all connections secure with proper voltage present. Opened condensing unit control panel and identified failed contactor preventing compressor operation. Contactor showed signs of electrical wear with pitted contacts and degraded coil. Replaced defective contactor with OEM equivalent rated for system specifications. Verified all wire terminations were tight and properly connected. Restored power and tested system operation. Confirmed compressor engaged properly, unit cycled normally, and system returned to full cooling capacity. Left system operational with customer satisfied.

Installed ground fault circuit interrupter (GFI) outlet at exterior deck location to provide code-compliant electrical protection for outdoor receptacle. Verified proper wiring connections, tested device functionality, and confirmed GFI trips appropriately when ground fault is detected.

Conducted comprehensive system evaluation of 20+ year old R-22 residential HVAC system exhibiting heavy damages in basement installation. Assessed furnace unit, ductwork connections, and condensate drainage system to determine replacement requirements. Documented equipment condition through photographic evidence showing deteriorated components, floor staining indicating potential drainage issues, and aging infrastructure requiring full system replacement estimate due to obsolete refrigerant type and extensive wear beyond economical repair.

Completed Club AC10-2 preventive maintenance agreement visit on residential air conditioning system. Performed comprehensive electrical diagnostics using clamp meter, recording amperage reading of 27.70 amps on outdoor condensing unit. Inspected all electrical connections, wiring, and components for proper operation. Documented existing condition of refrigerant line insulation showing deterioration and discoloration on suction line. System operating within normal parameters at time of inspection.

Completed scheduled maintenance agreement visit for club AC8-12 system. Performed comprehensive inspection of HVAC unit model DA1234AJINA, documenting equipment condition with photographs showing manufacturer specification label, serial number data, and safety notices intact. Unit exterior panel showed normal dust and dirt accumulation consistent with operational environment; all technical labels, voltage warnings, and bilingual safety notices remain legible and properly affixed to equipment housing.

Performed comprehensive heating system inspection and tune-up for real estate transaction compliance. Conducted complete furnace safety evaluation including carbon monoxide leak testing using calibrated digital CO meter, verifying zero detectable emissions and proper combustion operation. System confirmed operational with all safety parameters within manufacturer specifications and municipal code requirements.

Completed scheduled prepaid AC tune-up maintenance on residential air conditioning system. Upon arrival, found outdoor condensing unit with heavily soiled filter/mesh screen covered in thick accumulation of dirt, dust, and debris. Condenser coils showed relatively clean condition but filter obstruction was significantly restricting airflow. Performed comprehensive inspection of compressor, refrigerant lines, and condenser coil assembly. Noted debris accumulation in drip pan including dried leaves and organic matter. Cleaned filter screen and removed debris from unit base and drip pan. Inspected electrical connections and copper refrigerant lines, which showed normal operational wear and minor oxidation. Verified proper compressor operation and system functionality. Unit returned to optimal operating condition with improved airflow and efficiency.

Responded to no cooling complaint on residential air conditioning system. Upon arrival, found unit running but not cooling the home. Performed diagnostic testing and discovered failed contactor with severe corrosion and deterioration preventing proper compressor operation. Contactor showed heavy buildup of dirt, dust, and oxidation affecting electrical connections. Used multimeter to verify 0 volts at contactor, confirming complete electrical failure. Inspected terminal block connections and found extensive cobweb accumulation and aged wiring with signs of neglect. Replaced defective contactor and cleaned electrical connections at terminal block. Removed debris and cobwebs from electrical components. Tested system operation after repairs and verified proper voltage delivery to compressor. Unit now cooling properly with all electrical connections secure and functioning as designed.

Completed preventive maintenance inspection on club AC12-4 system. Performed visual inspection of condensate drain line assembly and associated plumbing components in mechanical space. Verified PVC drain piping, fittings, and shutoff valves are properly installed and functioning without leaks or blockages. Documented system conditions with photos for maintenance records. All components operating within normal parameters.

Completed Club AC12-4 preventive maintenance agreement visit on air conditioning system. Performed electrical diagnostics using digital multimeter, measuring voltage at 35.66V on system components and verifying current draw at 0.97A at the outdoor unit electrical panel. Inspected condenser unit wiring connections, contactors, and relays to ensure proper operation and electrical safety compliance.

Installed ground fault circuit interrupter (GFI) protection at exterior location near brick wall and chain-link fence boundary. Accessed main electrical panel in attic space, identified appropriate circuit for outdoor receptacle, and configured GFI breaker to provide required ground fault protection for exterior outlet. Verified proper operation of GFI device and confirmed circuit integrity upon completion.

Completed prepaid seasonal air conditioning tune-up on outdoor condensing unit. Performed comprehensive system inspection including electrical connections, refrigerant pressures, and component operation. Removed accumulated organic debris (leaves and dirt) from interior base pan and around fan assembly to ensure proper airflow and prevent motor strain. Inspected copper refrigerant lines, fan motor, and compressor for proper operation. Noted advanced concrete pad deterioration with significant spalling and surface damage, though unit remains structurally supported. All electrical connections tested and secured. System operating within normal parameters with no immediate service needs identified at time of inspection.

Completed prepaid air conditioner tune-up maintenance on residential AC system. Performed comprehensive inspection of outdoor condensing unit, including examination of condenser coil, refrigerant lines, and associated components. Observed accumulated dirt and debris in drip pan and on interior surfaces; cleaned accessible areas to improve operational efficiency. Inspected copper refrigerant lines, brass fittings, valves, and sight glass assembly for proper condition and connections. Verified drainage system components including PVC P-trap configuration. Unit operational at time of departure with no immediate service concerns identified. Recommend continued annual maintenance to prevent future issues.

Completed prepaid air conditioning tune-up and maintenance inspection on rooftop-mounted condensing unit. Performed comprehensive system evaluation including electrical connections, refrigerant line inspection, condenser coil cleaning, and internal component assessment. All mechanical and electrical components found operating within normal parameters with no deficiencies noted.

Responded to no-cooling complaint on 2-year-old Lennox AC system. Upon arrival, confirmed unit would not power on. Inspected low-voltage thermostat wiring and discovered damaged control wire between indoor air handler and outdoor condensing unit—wire insulation chewed through by rodents, causing open circuit. Repaired damaged section of thermostat wire, restored proper connections, and verified 24VAC signal at contactor. Tested system operation; unit powered on successfully with compressor and condenser fan running normally. Confirmed proper cooling cycle and advised customer on potential pest prevention measures to protect wiring.

Completed yearly preventative maintenance on two outdoor air conditioning condenser units, both approximately four years old. Performed comprehensive tune-up including removal of top panels for internal inspection, visual assessment of condenser coils and refrigerant lines, and evaluation of compressor components. Both units showed normal wear consistent with age and outdoor exposure, with minor dirt accumulation on coils and casings; no mechanical issues identified and systems operating within normal parameters.

# HVAC Service Report - No Cooling Emergency Responded to emergency service call for central air conditioning system producing loud hissing noise for approximately fifteen minutes before being shut down by occupant. Upon arrival, performed visual inspection of outdoor condensing unit, which exhibited significant weathering, dirt accumulation, and lack of recent maintenance. Unit showed heavy buildup of debris, grime, and environmental staining on exterior coil fins and surfaces. Conducted system diagnostic to identify source of hissing noise and determine operational status. Inspected refrigerant lines, connections, and condenser coil for potential leaks or damage. Evaluated compressor, fan motor, and electrical components for proper function. Checked refrigerant pressures and system charge levels. Identified active refrigerant leak as source of hissing noise. Located leak point and assessed severity of refrigerant loss. Due to extent of contamination on condenser coil and overall u

Responded to service call for malfunctioning thermostat with ongoing operational issues. Assessed existing thermostat system and determined replacement necessary due to persistent performance problems. Documented equipment information from furnace nameplate (Goodman ML296UH070XV36B unit) for proper thermostat compatibility and ordered appropriate replacement unit for installation.