Top-Rated HVAC & Water Heater Services in Wyandotte, MI

Completed warranty service on furnace unit by replacing defective door clips to ensure proper panel closure and system integrity. Verified secure door operation and confirmed all access panels were properly seated and functioning correctly upon completion.

Installed ground fault interrupter (GFI) protection for exterior electrical system serving HVAC equipment. Work included mounting weatherproof electrical enclosures on exterior wall, establishing proper conduit connections between junction boxes and main disconnect panel, and ensuring all wiring met code requirements for outdoor installations. All components were properly secured to vinyl siding with appropriate weatherproofing measures in place.

# HVAC System Installation Successfully completed full HVAC system installation in residential basement utility area. Installed new gray metal furnace unit with proper manufacturer specifications and blue-labeled front panel assembly. Mounted unit on concrete floor with appropriate clearances from surrounding walls and adjacent water heater. Installed complete white PVC venting and drainage system along right side of furnace, securing all vertical runs with multiple blue straps for proper support and code compliance. Configured PVC condensate drainage piping at base of unit with proper trap assembly to ensure efficient moisture removal. Installed white condensate pump near floor level to facilitate proper drainage operation. Connected flexible black corrugated supply duct to upper portion of furnace for air distribution. Verified all ductwork connections are secure and properly sealed. Ensured adequate clearance maintained between HVAC equipment and existing water heater with yellow

Completed installation of new air conditioning system and evaporator coil. Performed nitrogen pressure test at 1550 PSIG to verify system integrity and ensure no leaks in refrigerant lines and connections. Conducted final system diagnostics and pressure readings to confirm proper operation and refrigerant charge levels.

Conducted on-site evaluation for HVAC system replacement at residential property. Assessed existing York furnace and air handler unit located in basement mechanical room, documenting current equipment configuration including condensate drainage system, PVC venting network, and ductwork connections. Evaluated exterior condensing unit positioned in overgrown side yard area adjacent to building, noting accessibility challenges due to vegetation encroachment. Prepared comprehensive replacement estimate quotes 03625-07 and 03625-03 with photographic documentation of existing system components and installation environment.

Completed comprehensive estimate for replacement of existing outdoor air conditioning condensing unit and indoor furnace system. Evaluated current equipment condition, noting weathered outdoor unit with aging components and existing basement furnace installation, documented electrical disconnect configuration and venting systems, assessed installation site conditions including concrete pad placement and clearances, and provided detailed replacement recommendations for complete HVAC system upgrade.

Performed preventative maintenance agreement visit on air conditioning system. Upon inspection, discovered significant ice buildup on refrigerant lines and evaporator coil, indicating restricted airflow or low refrigerant charge. Removed and inspected blower wheel assembly, which showed normal operational wear. System requires further diagnostic evaluation to determine root cause of icing condition and restore proper cooling operation.

Completed preventive maintenance agreement visit on air handler and system inspection. Observed heavy frost accumulation on evaporator coil and refrigerant lines indicating potential airflow restriction or refrigerant charge issue. Documented electrical connections at control board showing proper wire terminations with wire nuts. System requires further diagnostic evaluation to determine root cause of icing condition, which may include checking airflow, filter condition, refrigerant charge levels, and metering device operation.

Conducted on-site evaluation for mini split heat pump system installation in residential dining area. Assessed room layout, wall construction, electrical requirements, and optimal placement for indoor air handler unit to ensure efficient heating and cooling coverage for the space.