Top-Rated HVAC & Water Heater Services in Allen Park, MI

Responded to callback for air conditioning system not operational. Upon arrival, verified electrical disconnect and conduit installation were complete with proper weatherproof enclosure mounted to exterior wall. Confirmed all electrical connections from disconnect box to outdoor condensing unit were secured and system was fully energized and functioning properly.

Completed comprehensive AC tune-up on 14-year-old system with no reported issues. Performed standard maintenance protocol including amperage draw testing (7.05A recorded), refrigerant pressure analysis across all ports, and system diagnostics using digital manifold gauges. All electrical connections inspected, condenser unit cleaned, and operational parameters verified within manufacturer specifications for continued reliable performance.

Completed full HVAC system installation including a 70,000 BTU Lennox furnace and 2-ton air conditioning unit with rear discharge configuration. Installation included all necessary mechanical and electrical connections, integration of humidifier system, and reconnection of existing components. System was pressure tested showing proper refrigerant charge at 127 PSI, with all copper refrigerant lines properly insulated and secured. Furnace was mounted on concrete blocks in basement location with complete PVC venting system installed, electrical panel connections completed, and all ductwork properly configured and sealed.

Completed routine CLUB AC 8-12 preventative maintenance agreement visit on air conditioning system. Performed comprehensive diagnostic testing using digital multimeter to verify electrical measurements at 317 volts, confirming proper power supply to unit. Utilized digital gauge manifold to monitor refrigerant pressures and temperatures, recording low-side pressure at 10.8 PSI and high-side pressure at 280.0 PSI with corresponding temperature readings of 134°F and 97°F. System operating within normal parameters. All measurements documented for maintenance records.

Completed comprehensive AC tune-up on residential split system. Performed inspection of outdoor condenser unit, verified proper operation of blower assembly and control boards, and assessed overall system performance. Unit found in good working condition with normal dust accumulation; all electrical components and connections functioning properly.

Installed a GFCI receptacle on the exterior brick wall of the building. The outlet was properly mounted in a weatherproof protective cover with appropriate hardware to ensure code compliance and protection from the elements.

Completed full HVAC system installation including a 70,000 BTU furnace and 3-ton air conditioning unit with rear discharge configuration. Installed humidifier, established proper condensate drainage with PVC piping and condensate pump, and reconnected all electrical and mechanical connections. All ductwork, refrigerant lines, and control wiring were properly routed and secured to ensure efficient system operation.

Performed comprehensive system evaluation of aging HVAC equipment including a 16-year-old Goodman furnace and 14-year-old air conditioning unit located in basement mechanical room. Assessed existing ductwork configuration, gas line connections, and electrical components. Documented current system condition through photographic documentation showing furnace cabinet, air handler, metal ductwork with moisture presence, and associated utility infrastructure. Provided complete system replacement estimate as alternative to repair options after determining equipment age and condition warranted full replacement consideration.

Conducted on-site assessment for HVAC system replacement estimate. Documented existing equipment specifications by photographing furnace and air conditioning unit model and serial numbers for accurate equipment sizing and replacement recommendations. Evaluated current thermostat configuration, noting dual thermostat setup with programmable digital and manual Honeywell units. Inspected electrical service panel and associated wiring to verify adequate power supply for potential new equipment installation. Completed photographic documentation of basement utility area and control locations to support comprehensive replacement proposal development.

Completed prepaid annual air conditioning maintenance on residential HVAC system located in basement mechanical room. Performed comprehensive AC tune-up including inspection of furnace, ductwork, humidifier unit, and associated components. System components inspected included galvanized metal ductwork with visible mineral deposits on humidifier supply plenum, copper refrigerant lines, white PVC condensate drainage, and air filtration system. All mechanical equipment evaluated for proper operation and seasonal readiness, with photographic documentation captured of equipment condition and installation.

Responded to service call for air conditioning unit running loud and not operating properly. Upon inspection, found faulty contactor with signs of wear and pitting on contact points causing excessive noise and intermittent operation. Replaced defective contactor and verified proper amperage draw of 61.1 amps during system operation. Tested all electrical connections, confirmed proper voltage supply, and verified unit is now operating quietly with normal cooling cycle.

Completed scheduled CLUB AC 8-12 maintenance agreement visit for air conditioning system and safety inspection. Performed comprehensive inspection of air handler unit, verifying proper operation of CarSense control module and all associated electrical connections including multi-wire harness with color-coded wiring. Confirmed all wire terminations secure and properly bundled. Inspected refrigerant lines and copper tubing for leaks or damage. Conducted outdoor condenser unit evaluation, checking refrigerant pressures and system performance using gauges and diagnostic equipment. All components operating within normal parameters with no deficiencies noted at time of service.

Completed preventive maintenance tune-up on Lennox ML296UH070XV3SB furnace system with 65,000 BTU capacity. Performed comprehensive inspection of heating equipment, verified operational safety controls including flame sensor and LED diagnostic indicators, and documented system specifications. Inspected associated HVAC components including condensate pump, PVC drainage system, and air filtration equipment to ensure proper seasonal operation.

Completed scheduled maintenance visit for air conditioning system under preventative maintenance agreement. Upon inspection, discovered evaporator coil heavily contaminated with dust, dirt, and biological growth accumulation, significantly reducing heat transfer efficiency and airflow. Accessed air handler cabinet and documented interior condition showing moisture staining and general wear consistent with unit age. Performed thorough cleaning of evaporator coil to remove yellowish-green buildup from fins and restore proper airflow. Inspected cabinet interior components, mounting brackets, and support frames for structural integrity. Cleaned condensate drain channels and verified proper drainage to prevent future moisture issues. Unit returned to normal operating condition with improved cooling efficiency.

# Plumbing Estimate - Water Heater Replacement Conducted on-site assessment for 40-gallon residential water heater replacement in basement utility room. Evaluated existing water heater installation, copper supply piping configuration, and venting requirements. Documented current plumbing connections including hot and cold water lines with shut-off valves, temperature and pressure relief valve discharge piping, and existing gas line routing. Inspected basement mechanical room layout and confirmed adequate clearances for new equipment installation. Noted existing water heater connections include copper supply lines with compression fittings, galvanized pipe sections, and multiple valve assemblies. Assessed condition of existing plumbing infrastructure and identified sections requiring replacement or modification during installation. Prepared three separate quote options (03556-04, 03556-05, and 03556-08) for 40-gallon water heater replacement with varying specifications and installat